Category: Cooltech series receiver  Publish Time: 2018-04-02 10:50 
S-FHSS compatible receiver


Operating Voltage Range : 3.5~8.4V
Dimension : 35.5X23.3X12.7mm
Weight : 7.3g
Operating Range : Full range
Number of Channnels : 4 standard channels+ S.BUS channel(8CH from S.BUS channel)


Cooltec 2.4GHz S-FHSS Compatible Receiver is designed to use with FUTABA S-FHSS Surface Systems, such as
3PV, 4PV, 4PX, 7PX, etc.


-- Ultra mini size and light weight
-- Improve capability of anti-interference
-- Replaceable antennas
-- Upgradeable firmware
-- Rather long operating range with PA
-- Boost up circuit design, perfect for RC car

Bind procedure:

1) Turn on the transmitter, get to the SYSTEM and select S-FHSS;
2) Connect battery to the receiver, take the receiver close to the transmitter within 20 inches(half meter);
3) Press and hold the F/S button on the receiver more than 2 seconds, the LED on the receiger changes to solid
green indicates binding successfully;
4) When the ID can not be read due to the surrounding environment, try to read it with the transmitter and receiver antennas touched.

If there are many S-FHSS systems tured on in close proximity, your receiver might not link to your
transmitter. In this case, even if the LED of the receiver stays solid green, unfortunately the receiver
might have established a link to one of the other transmitter, this is very dangerous if you do not
notice this situation. In order to avoid the problem, we strongly recommend you to double check
if your receiver is really under control by your transmitter by giving the stick input and then checking
the servo response.

Previous: STC4  Next: D16-1