RFA16
Category: Cooltech series receiver  Publish Time: 2017-12-06 14:22 
D16 compatible receiver

SPECIFICATIONS:

Operating Voltage Range  : 3.5~8.4V

Dimension:46.7X14.6X36.8mm

Weight:12.5g

Latency:14ms(LS) 

              :7ms(HS)                      

Sensitivity:about -96dBm 

INTRODUCTION:

Cooltec 2.4GHz Spread Spectrum FASST Compatible Receiver is designed to use with FUTABA  FASST 2.4GHz Air System(7CH Mode/Multi Molde), such as TM7, TM8, TM10, TM14 or T6EX-2.4G, 7C-2.4G, 8FG, 10CG, 12FG , 14MZ, 14SG, 18MZ.

BINDING PROCEDURE:

Turn on the transmitter, get to the LINKAGE MENU - SYSTEM and select FASST-7CH or FASST- MULT, Connect 

battery to the receiver while holding the F/S button on the receiver, the red LED on the receiger is off  and green LED constant on indicates binding successfully.

SETTING FAILSAFA:

RFA16 support two delectable failsafe setting options, either use native failsafe position preset on transmitter, or set failsafe on RFA16.

1) Use native failsafe position preset on the transmitter side:

If not disabling failsafe on the transmitter side, RFA16 will use native failsafe position preset on the transmitter side.

2) Set failsafe on RFA16:

RFA16 supports failsafe function for all trannels. Follow the steps below to set failsafe positions for each channel.

(1) Bind the receiver first and disable failsafe on the transmitter side;

(2) Set all transmitter controls to the desired failsafe position;

(3) Press briefly the F/S button on the receiver(less than 1 second), the green LED will flash twice, indicating the failsafe is set up successfully;

(4) To disable the failsafe fuction, just need to rebind the receiver.

 HOW TO SWITCH BETWEEN LS AND HS MODES:

Turn the transmitter off, connect the battery to the receiver, press the F/S button of receiver for 6 seconds and then release. The red LED will flash fast in HS mode and slow in LS mode. Reapeat this to alternate modes.



Previous: D8-1  Next: RFA04C